Gently used Honda Flashpro with Bluetooth. Complete with original box.
Civic Si 2012 / ILX 2013 Americas
$450USD shipped in the continental US. Shipping to Alaska, Hawaii, and Canada at buyers expense.
Located near Sacramento, CA
Thanks for looking.
I am also near Sac.
I just removed my S2 downpipe/intake and removed my Hondata tune and passed smog with no issue.
What CEL codes are you seeing? Are they related to o2 sensors?
If you have a JL 500/1v2, here are the steps to tune the amp:
To start:
Turn bass knob all the way up
and flatten out deck eq
Check LOC output to verify it is Low = 200mV and 2V High = 800mV and 8V
Preamp Output Section:
-Output Mode: Amp Filter
-LP filter suggested: 12dB
Advanced...
Conclusion:
I tapped into the wires at the sub with the wire to rca connector. That resulted in too high of output for my amp to handle on high or low input.
Installed LC2i and that brought that down to an acceptable level. Now my amp is running optimally per the instruction manual.
In all...
Installed the wire to rca adapter at the plugs to the amp. It appears to not have enough voltage to trigger my SMD DD-1 or JL Audio 500/1 v1 amp. Verified amp is set on Input Voltage: Low = 200mV and 2V.
The factory sub is still functional, so I know there is output from the amp to sub.
I'm...
Washed the car today. It had some knarly tree sap on the front end. I tried Sonex Spray and Seal for the first time. A little goes a long way and resulted in streaks. I had to follow it with Detail Spray to clear all the streaks. Too much = more work.
Looks and feels great tho!
1. If you are swapping the head unit, you don't have to worry about the original outputs.
2. Yes, but with more power output from the new stereo and possible amp, you may blow them and require replacement later.
3. An aftermarket microphone will probably be better quality than the stock one...
I just installed an audio control lc2i pre amp (before the factory amp) but not getting rca output.
It is designed for line level outputs (after factory amp). This is bad since the amp filters frequencies out.
The other option is to install wire to rca pigtails, but there are only 2 sub wires...
Removed
Skunk2 downpipe
Skunk2 CAI
Hondata Flashpro tune
My car is old enough to need a smog. I doubt these parts will be reinstalled. Man the car is so quiet.
Check to see if there is a loose cable from alternator to chassis and battery negative to chassis.
Make sure the TPS sensor and MAF sensor cable are connected correctly.
Codes:
P0122 - Throttle Position Sensor
P0222 - Throttle Position Sensor
P0113 - IAT Sensor Circuit High Input Problem...
I know this is an old post, but here is your answer.
Here are the spec's of the sub channel on this amp:
Subwoofer Channel @ 4 Ω 180 W RMS x 1
Subwoofer Channel @ 3 Ω 240 W RMS x 1
Subwoofer Channel @ 2 Ω 300 W RMS x 1 >
Speaker that matches those specs the best from JL Audio is a 10tw1-2...
I have to disclose I'm a contractor at Google. With that said there are a lot of iPhones on campus since contractors aren't supplied phones by Google since that isn't our direct employer.
I am digging this phone. The processor speed is incredible compared to the S5. I got the 128GB model, so I...
I was looking around to see if there was any information regarding if the CT-Engineering Supercharger for the 12-15 SI has gained the Carb EO exempt status. Unfortunately it looks like it didn't make it and is not legal to run in states with emissions testing.
I'm glad I help off until this has...
I have the Nestcam/Dropcam and my only complain is for history or recording I have to pay a monthly or annual fee per camera.
Is there a free recording service that doesn't require a computer to be on all the time or a DVR to be connected to the network?
I change my brake fluid every 2 years and my transmission fluid every 30k.
The manual transmission on a honda is pretty easy to drain and change. The plug is on the driver side and you use the upper to fill the transmission, the lower to drain. I use a rubber hose connected to a funnel to get...
I would have to research which slots are live (constant) when the ignition is off.
I don't know why they would include the black in that style fuse, it would be better as an inline fuse and hook it to the nut the fuse box is tied down with or a bolt that goes into the car chassis.