Search results

maybe, i was thinking of using foil tape and caulk to make a flexible patch over the areas and let me free up most of the way to the heat sink

i think its just a corner i need to see if i can take it off and jbweld over myself

the driver is mounted to the back where the low beam would have been, the harness comes through its grommet in the bottom of the light

It will be a bit to get them on the car, the frankensteined headlight hits the front radiator support and crash frame structure, so i need to do a little reshaping on the headlight to make it clear

i think the ILX DRL is also a switch back turn signal, or the upper light bar is the turn signal

i think the front of the ILX and TLX headlights are narrower, but i dont know if they made the heat sinks smaller too. the ILX has reflectors for the high beam emitters too instead of the lenses last i looked

gotta figure out if the accord DRL is pulse width modulation like @iShift_6 found on the civic or if the accord uses a reduced voltage

i think well worth the wait, as usual Rich doesnt disappoint

Santa came early, paying for them shortly

hey, curious if youve had a chance to update the parts list and wire diagrams for the lighting controller yet

MXM4s are the stock spec tire for my accord, theyre ok tires, after a particularly fun trip to the dragon the tires were completely shot in terms of their grip despite being at 5/32. I replaced them with Continental DWS06s and they are far better and cheaper than the MXM4s

i believe plastic welding and heat methods to piece it all together

i didnt have a chance to harass him yet, he sent the pics to me unprompted, but he says should be a few more days to finish, but hes already at a solid 3 weeks of labor

@webby

wheels turned slightly

i would love to put that lip on but im afraid i would destroy it, the car was designed to have a 4+in higher front end than the rear, i scrape the bumper on everything

the rears actually sit fine inside the car, its just the fronts last alignment after suspension install

Just the fronts were rubbing on speedbumps and stuff, i could go lower but since the tires/wheels extend a little past the fender id have to do some hella flush style camber

remember the AR platform is like a car, sure the base components are 700-1000 but then you start modifying and upgrading and easily dump 4k into a rifle build

Looking shiny in the back of the parking lot Getting to be time to rattle Rich's cage about the other headlight too