MAF Sensor Screw Size?

[Nefertiti_Civi]

Hey guys,

I can’t seem to find the size of screws that go on our MAF sensor for the SI. I picked up a PRL SRI, and the sensor of course doesn’t stay flush without the screws. And I lost mine. Anyone have any guidance on the size of the two screens that go there? Thank you for the help. Couldn’t find it by searching for some reason.

 

[Sarcras]

I think what you are looking for are #16?
https://www.collegehillshondaparts....exhaust-heater-fuel-cat/air-cleaner-2-4l-scat

 

[Nefertiti_Civi]

Thank you so much @Sarcras. got em ordered. I appreciate it!

 

[Sarcras]

You're welcome! Glad I could help.

 

[dpetro1]

Thank you so much @Sarcras. got em ordered. I appreciate it! [emoji106]

I hope you didn't pay to have 2 screws shipped. Nothing wrong with oem but you can pick up 2 m4x.7 bolts at your local hardware store for under $1.

Sent from my SM-G920V using Tapatalk

 

[Nefertiti_Civi]

I hope you didn't pay to have 2 screws shipped. Nothing wrong with oem but you can pick up 2 m4x.7 bolts at your local hardware store for under $1.

Sent from my SM-G920V using Tapatalk

@dpetro1 I should have looked there, but I think I paid about 2ish for both for going to my local Honda. I just never knew the size lol.

 

[dpetro1]

All good. In the future you can also get the size from the factory diagram.
From the link above, the part name is followed by (4x10).
This is the bolt diameter and length. In this case m4 with 10mm length. It does not give thread pitch but that is standard
M4 x 0.7
M6 x 1.0
M8 x 1.25
M10 x 1.25

Sent from my SM-G920V using Tapatalk