Built By Notorious: 12' Silver Si Sedan; Project Wifey's Daily

Built By Notorious

Well-Known Member
42
19
Phoenix
Hello all!
We are Built By Notorious of Phoenix AZ. We are a import performance shop .. Here is my wife's project daily driver that we just picked up for her about a week or so ago.
ImageUploadedByTapatalk 21368930116.607368.jpg
ImageUploadedByTapatalk 21368930148.691268.jpg
ImageUploadedByTapatalk 21368930185.780357.jpg
ImageUploadedByTapatalk 21368930233.241139.jpg
And it begins...
BWR 8th Gen Civic 2" Drop Springs
ImageUploadedByTapatalk 21368930281.874243.jpg
BWR Aluminum Red Lug Extended Nuts, BWR Short Shift Adapter from 8th Gen Civic, 9005 3k Yellow Running Light Bulbs, Honda OEM 8th Gen Civic rear upper coil spring isolators
ImageUploadedByTapatalk 21368930476.691267.jpg
 
Awesome. I'm looking forward to the build.
 
BWR drop spring installed in the front.
ImageUploadedByTapatalk 21368930614.489753.jpg
Fresh off the lift.
ImageUploadedByTapatalk 21368930642.205505.jpg
Before and after.
ImageUploadedByTapatalk 21368930668.672532.jpg
Rear settling after 1st test drive!
ImageUploadedByTapatalk 21368930703.639083.jpg

More to come... Still have to Install a few parts I have already stock piled.. Lol
Next up
9006 Hid Kit 6k low beam
9005 Halogen 3k Yellow Daytime running / Hi Beam
BWR Short Shift Adapter from 8th Gen Civic
1 x 12" Rockford Fosgate p1 Sub w/ 500 Watt amp
Rear View Camera Hack
Mid muffler delete
Intake Resonator delete with K&N drop in filter
(Intake and exhaust mods will be temporary till we decide if we are turbon' it or not)
 
Hey good to see you on here. I used to be on AZHT a lot when I had my ej8. Cars looking good so far!
 
Need anything special to install those 8th gen springs on? Cause damn that's a low *** drop if it is 2 inches lol

Just the rear upper spring perches from an 8th gen., 2" drop was for an 8th gen also. I think it's closer to 2.5 front tho on our 9th. Rides nice and handles a little better. Will do the job till I can justify K Sport money after some more mods.
 
Just the rear upper spring perches from an 8th gen., 2" drop was for an 8th gen also. I think it's closer to 2.5 front tho on our 9th. Rides nice and handles a little better. Will do the job till I can justify K Sport money after some more mods.

Damn that's pretty low for springs, I'm assuming you needed camber kits?
 
Just my two cents, sportlines springs from eibach are made for the 9th and offer about the same drop

Correct they are a touch higher in the rear. I'm ok with it for now. Can't complain for a drop spring that retails at half of the cost of Ebiach and only temporary.
 
Got a couple more parts in for wifey's Si!
Spec D: Rear camber arms 06-13 Civic
ImageUploadedByTapatalk 21369362371.937082.jpg
Eibach: Front camber bolts
K&N: Drop in air filter
e4eqahat.jpg

Need to make time to put these on, get it an alignment.
 

Attachments

  • ImageUploadedByTapatalk 21369362502.403501.jpg
    ImageUploadedByTapatalk 21369362502.403501.jpg
    84.7 KB · Views: 6
Back
Top