Phroze
Well-Known Member
Ok so i'm messing around with my boost controller and during this process, my boost will sometimes spike past 10psi and throw a CEL.
I'm currently set up for 9lbs and i'm using the Stock MAP sensor. I have a 4bar map sensor on hand but when i replace the stock one with it, will i need a full retune or can i just reload the same exact calibration with the 4bar sensor selected?
@VitViper or anyone else who would know
thx in advance
I'm currently set up for 9lbs and i'm using the Stock MAP sensor. I have a 4bar map sensor on hand but when i replace the stock one with it, will i need a full retune or can i just reload the same exact calibration with the 4bar sensor selected?
@VitViper or anyone else who would know
thx in advance