Building for boost

Discussion in 'Forced Induction & Nitrous Oxide' started by SpikedJoker, Aug 7, 2018.

  1. SpikedJoker

    SpikedJoker Well-Known Member

    Messages:
    33
    Location:
    77422
    Vehicle Model:
    Civic
    Body Style:
    Si. Coupe
    So this is my first serious build for a Honda motor or anything past simple intake and exhaust mods or cosmetic. I have a 12 civic Si with the k24z7 and so far it's only had sk2 carry back and cai installed with coil overs from tein. I'm looking at the end result being boosted with a turbo but for now, intake manifold swap and throttle body. Exhaust manifold will go when I get the turbo supported and decide on internals. For now, I could really use advice on who had it in the hp/tq department. Real numbers. Rbc, skunk 2 ultra .
     
  2. webby
    • Staff
    • 2019 Toys For Tots

    webby Administrator

    Messages:
    50,249
  3. SpikedJoker

    SpikedJoker Well-Known Member

    Messages:
    33
    Location:
    77422
    Vehicle Model:
    Civic
    Body Style:
    Si. Coupe
    Thanks for the link but very few pay their mods with the dyno results so it's rather difficult to keep track of who had what and did what with it especially with the whole debate over edyno and other topics.
     
  4. webby
    • Staff
    • 2019 Toys For Tots

    webby Administrator

    Messages:
    50,249
    if they didn't post their mods in the thread, they usually have it in their build thread. Many have had edyno from vitviper and have done another dyno at a shop with almost identical results. Numerous were within 5hp
     
    R3KONT3K likes this.

Share This Page