That helped a lot but when tighten down the bolts there is a space between the head of the bolt and the washer because the little thing that indeeds against the strut knuckle is there so I just tighten it and close the space or is there always a space between there after I torque it down? I'll...
I'm lowered on skunk2 springs and want to run more camber in front for my 245 tires. I already have one eibach camber bolts up front. I just bought anyone to have two on each side. Question is when I installed the second bolt for the bottom of the strut. It made no different. The bolt just spins...
I have a 1/2 snap on, dewalt, and craftsman. They are all strong. I think the snap on one is just a bit stronger than the rear but with craftsman gun deal for $99.00. You can't beat it compared to snap on $600.00 or dewalt $500.00. So if money is not a issue snap on but craftsman for the beat bang
I have rpf1 17x8.5 +30 on my Si Sedan. I have 215-45-17s at the moment and want to go wide. I plan on going 235-45-17s, but was wondering if anyone went with that size with the same specs as my wheel. I want to go as wide as I can without too much camber. I know I will probably have to roll my...
There's another on that there's a rattle in the dash when on low to medium speed on cold on the defroster. It's the door flap to the heater core. I got my replaced. They have to take off your whole dash
Just took some photos of my Civic Si and a couple of my cousin's S2000 yesterday night at a garage. Nothing special. I didn't edit the pictures. I suck at taking pictures, but I tried. lol
Hate and love comments are welcome!