PWJDM Gurney Flap

This should fit. It is a direct replacement for the top part of the trunk lid. It would replace the area with the emblem and 3rd brake light. You might have to extend your brake light wires as this will protrude further than the ex
 
Twitch said:
This should fit. It is a direct replacement for the top part of the trunk lid. It would replace the area with the emblem and 3rd brake light. You might have to extend your brake light wires as this will protrude further than the ex
Click to expand...
@Twitch this doesn't replace anything. It's just a little extra lip that fastens on top of the existing Si trunk spoiler. The picture on the passwordjdm site is just showing the Si spoiler removed.
I think @Danny Hsu is asking if it will fit a non Si trunk lid.
 
JonnyRotten said:
@Twitch this doesn't replace anything. It's just a little extra lip that fastens on top of the existing Si trunk spoiler. The picture on the passwordjdm site is just showing the Si spoiler removed.
I think @Danny Hsu is asking if it will fit a non Si trunk lid.
Click to expand...

Oh gotcha I was confused why it was showing the entire trunk lid but said gurney flap.
 
Danny Hsu said:
Yes, both trunks look pretty similar in terms of the shape. I just wanted to see if anyone can confirm that the curvature of both trunks are the same.
Click to expand...
I'd contact pwjdm and ask how flexible the flap is. If it's not real rigid, it'd probably could be stuck to the EX. It's just held on by 3m tape
 
I would be concerned with the length. I believe the si lid is longer as the spoiler protrudes more. While you may be able to conform to the curve the flap will actually be too long on the ex. Maybe the vendor can provide some dimensions
 
You must log in or register to reply here.
Back
Top