So instead of buddy clubs I got these skunk 2 style camber fml

[maark808]

So I was wondering what is that black stuff on the first picture? and on the second picture that shouldn't be there right? anyone know how to set it up

 

[CivicCanuck]

Those are external snap rings on the stud. From the look of it, they are there to make adjustment easier, you would loosen the nut, remove a snap ring and tighten the nut up, to check the results, rather than remove the nut, remove washers, re-install the nut, etc. No instructions online on the manufacturers website?

 

[maark808]

Those are external snap rings on the stud. From the look of it, they are there to make adjustment easier, you would loosen the nut, remove a snap ring and tighten the nut up, to check the results, rather than remove the nut, remove washers, re-install the nut, etc. No instructions online on the manufacturers website?

check the second picture shouldn't I remove it and put the longer stuff in there

 

[Dar-Dar]

It is poorly assembled. I don't get the point of all those washers being there. And that hollow metal rod shouldn't be in there...

Where did you get the camber arms?

 

[maark808]

It is poorly assembled. I don't get the point of all those washers being there. And that hollow metal rod shouldn't be in there...

Where did you get the camber arms?

yea I figured ima hammer it out , and the first picture I just put everything there so I don't lose it. Okay I figured out how to set it up.