Just receive my Skunk2!!!

2012si2012

2012si2012

Well-Known Member
80
21
Montreal
Vehicle Model
Si
Body Style
sedan Si
Hi i want to share with you my new skunk2 coil.

hT7Yh.jpg


OmR30.jpg


3dXp3.jpg


but i cant remoove those coil off together.... i dont know how to do
 
:think: what is stopping you from untwisting them like he mentioned?
 
twist in one direction... see if it goes. If it's too tight to spiral out of the top coils, you need to twist it in the other direction. No clue how else to tell you to do it.
 
It's like undoing a slinky. Lol.
 
The small end of the coils there is one that is higher than the other(small ends down as in the pic)........... Un screw the higher one from the lower one........turn the higher one ccw (looking down on it).

You could fill up the kitchen sink with soapy water while working with it.
 
IMPOSSIBLE... i will wait till i go to the garage... maybe he will find a way... cause... im out of solution....lol
 
It looks like if you hold it like you have it in the picture, pull the top of the right on towards you and to the right a little bit, and do the opposite with the left, and maybe twist them a little bit, they'll pop apart. Just my 2 cents on that.
 
Email Skunk2. Lol. Maybe you will get store credit of some sort because that isn't convenient.
 
spazerboy said:
It looks like if you hold it like you have it in the picture, pull the top of the right on towards you and to the right a little bit, and do the opposite with the left, and maybe twist them a little bit, they'll pop apart. Just my 2 cents on that.
Click to expand...
Yeh ... your right they aren't screwed together they're just pressed together........
 
In the last picture. Hold the one on the right down and pull the one on the left towards the ceiling
 
You must log in or register to reply here.
Back
Top