9th Gen 2012 Civic Short Shifter Finally Here!

IMG_20120927_133209.jpg

Are you kidding me?? HOW THE **** do you take out this shifter?????? I'm about to give up, too many pieces you have to take apart to get to this damn thing.. Not worth it!
you got the 2 front bolts out? the 2 cables have tabs you lift up then they will spin(spring tighten o make sure you hang on)
 
S2KJAY theres 2 screws in the center console remove those then pull the whole thing out of the way
so you wont have to pull the shifter cables off
 
K got my stuff done.. Wasn't easy i.m.o., especially getting the little blue cap off.. Some pics for everyone:
twm bronze shift knob
IMG_20120926_155911.jpg

IMG_20120926_155926.jpg

IMG_20120926_160228.jpg

IMG_20120926_160256.jpg

Install
IMG_20120927_133209.jpg

Threaded down to the base and also cut about an inch of thread off
IMG_20120927_173627.jpg

shot of the S. shifter and the stupid blue cap.. GOOD LUCK getting it off!
IMG_20120927_155419.jpg

driver side final shot
IMG_20120927_182845.jpg

passenger side
IMG_20120927_182902.jpg
 
its easy to pop the blue cap off with like an open wrench.. stick it between the shifter shaft and the cap and pop the cap off.. to put it on, i just put the cap on the short shifter and pressed it against the ground.. armo can vouche for that haha
 
spdandpwr well, a couple of things I noticed with this setup: 1- because the knob sits a little more than an 1.25 inches lower, it is stiffer because I'm now closer to the actual ball joint.. the height is VERY nice, perfect actually.. and the short shifter extension is a dream.. combined with the shorter height makes for a very stiff and precise short throw.. the added threading I did combined with the top inch trimmed off gave me a very low setting.. I'm happy!
 
Back
Top