FB2Chris' PMM FB2 MT (v2)

My new tires have been mounted and I had an alignment done as well. The fronts weren't touched, but the rears needed some adjusting. Final alignment readings:
Alignment_9-21-13_zps1cb16c8c.jpg
 
They look nice. You couldn't cut around the covers at all? I guess the only trade-off with stiffening your chassis is a slight loss of mpgs.
 
Dar-Dar said:
They look nice. You couldn't cut around the covers at all? I guess the only trade-off with stiffening your chassis is a slight loss of mpgs.
Click to expand...

I didn't check, but I'm sure I can figure something out. As long as I have it done by time it snows I'll be ok.

323 said:
i'm planning to just cut out a space in the covers for the braces with a dremel
Click to expand...

The front tie bar will fit fine over the underbody covers as the two mounting bolts are exposed. It's the chassis brace that requires modification to the underbody covers. I can't remember if the two bolts on the subframe are exposed for the chassis brace, but I know the other two bolts are not.
 
Pauly99to17 said:
Wow! Really nice. Getting colorful underneath.
Click to expand...

Thanks. The blue, purple, yellow scheme isn't bad.

Pauly99to17 said:
Dam! Looks clean under that car.
Click to expand...

Lol. For being a northeast car and seeing two snow seasons already, I know. I bust my *** cleaning my car (I'm doing it right now). Rain, snow, or shine, I make sure to clean it once a week :D
 
I also put two of the three underbody covers back on. I haven't figured out how (or if) I can fit the engine underbody cover on with the chassis brace.

@323 here's what I did with the two covers that run along each side of the underbody. I broke my dremel so I used some heavy duty scissors.
20131002_145319_zps22305ae5.jpg

20131002_145336_zps854e7f6f.jpg
 
You must log in or register to reply here.
Back
Top