Nevtec
Well-Known Member
Oh haha. I was gonna say that's a dam clean 07 :P
Post Your Latest Purchases
- Thread starter iluvmycsx
- Start date
CivicCanuck
Well-Known Member
FKX Racing:
1x tower bar
1x front lower tie bar
1x rear lower tie bar
1x x brace
1x trunk brace
1x tower bar
1x front lower tie bar
1x rear lower tie bar
1x x brace
1x trunk brace
KennyGS
How may I help?
Installed yet? Noticeable improvement?
Dar-Dar
Mordorator
- 19,329
- 9,901
- Vehicle Model
- Civic Si
- Body Style
- Fiji Blue Pearl Coupe Coolest Member Since: May 15, 2011
Im not sure if the 8thgen and 9thgen can both use the same sets of jdm emblems. I'll check around.
CivicCanuck
Well-Known Member
Not installed yet... just picked up the last 2 pieces. Going to install them when I have a chance, but it may not be for a few months, I have been working and concentrating on my truck, it's on the road but there are a lot of loose ends to tie up. It's already started snowing, and I haven't even rustproofed for the season yet.
Would be nice to get some back to back runs in the same day with and without to see the difference.
LizBot
Well-Known Member
Autocraft Silver Battery
Didn't feel like shopping around. So I hope this lasts at least a handful of years.
Didn't feel like shopping around. So I hope this lasts at least a handful of years.
team3d
Well-Known Member
bought this car 5 days ago...
No more Civic?
91alexm
Well-Known Member
J-Rizzy615
Well-Known Member
- 13
- 3
CivicCanuck
Well-Known Member
Just fabricated this sweet panel last night for my pickup. Installed a GM 4 pin weatherpack connector on the main harness, and a 2 pin on the output from the switches.
Gauges are Intelletronix, trans temp and voltage. This console had a large opening at the front, originally in a Tahoe. ( they had rear heat controls there ) Pickups got a smaller opening on the console and a blank filler panel, the tahoe and suburban consoles are the perfect size for 2 1/16" gauges. Autometer angle rings rotate the gauges up towards eye level and towards the driver.
Made a template from thin cardboard and transferred that to 1/4" black smoked Acrylite sheet. I had to use two pieces of 1/4" to make up for the thickness of the original temp controls and be flush in the opening.
Gauges are Intelletronix, trans temp and voltage. This console had a large opening at the front, originally in a Tahoe. ( they had rear heat controls there ) Pickups got a smaller opening on the console and a blank filler panel, the tahoe and suburban consoles are the perfect size for 2 1/16" gauges. Autometer angle rings rotate the gauges up towards eye level and towards the driver.
Made a template from thin cardboard and transferred that to 1/4" black smoked Acrylite sheet. I had to use two pieces of 1/4" to make up for the thickness of the original temp controls and be flush in the opening.
team3d
Well-Known Member
i have both now....
