Squiggy's 2012 DBP II Si Coupe

axion_industries said:
Have you noticed the better shifting and no wheel hop?
Click to expand...

Shifting is much better now. Hard to attribute it to just the mount though as I swapped out the clutch line for stainless steel, put in DOT4, and removed the clutch delay valve.

Wheel hop is definitely gone as far as I can tell. Slight side effect is more torque steer since the engine isn't moving as much.
 
Got the garage all nice and toasty warm. Time to work on some soundproofing. Hopefully I can get most of it done tonight.
 
Ran out of propane and them completely blew a GFCI. :(
 
323 said:
That sucks...I've found that throwing a wrench at the wall really helps when things don't go right
Click to expand...

My fault. I had a halogen on. A 1500w radiant space heater and a small heater. Propane for the heater ran out, which I was holding pieces of the soundproofing in front of to warm up and make it pliable. So, I grabbed a blow dryer. BAM! Blew the GFCI. I was trying to pull too much wattage.
 
So could the gfi not be reset? It actually killed the gfi entirely?
 
Another two hours and I should have the trunk almost fully soundproofed and back together. I will just have a bit left to do on the lid.
 
You must log in or register to reply here.
Back
Top