Rear Sway, short throw shifter, and engine mount help

twister8008

twister8008

Well-Known Member
860
480
Omaha, NE, but I am a Wisconsinite
Vehicle Model
Civic SI
Body Style
Coupe
I would love to upgrade my suspension a bit. I have an HFP suspension currently with no other mods. I would like to tighten up my suspension with a 24mm rear sway bar. I also would like to shorten up my shifts. I am looking at the buddy club and billet pro sets. Finally, I am looking to install the Boomba Racing engine mount. Can anyone provide guidance, advice, or a testimonial on these products? Thanks for the help!
 
Dar-Dar

Dar-Dar

Mordorator
19,329
9,900
North NJ
Vehicle Model
Civic Si
Body Style
Fiji Blue Pearl Coupe Coolest Member Since: May 15, 2011
The 22mm is a better choice for a rear sway bar, imo. Unless you'll be tracking your car in an occasional manner. It's also about $100+ cheaper than the 24mm. With that you can get better sway bar bushings and beefier end links from MOOG. Here's a thread I made regarding the Progress bushings: http://9thcivic.com/forum/threads/rear-sway-bar-bushing-upgrade.10188/
 
squiggy

squiggy

Cartographer
Super Mod
11,183
6,654
Michiana
Vehicle Model
'12 Civic Si
Body Style
DBP II Coupe
Dar-Dar said:
The 22mm is a better choice for a rear sway bar, imo. Unless you'll be tracking your car in an occasional manner. It's also about $100+ cheaper than the 24mm. With that you can get better sway bar bushings and beefier end links from MOOG. Here's a thread I made regarding the Progress bushings: http://9thcivic.com/forum/threads/rear-sway-bar-bushing-upgrade.10188/
Click to expand...

Depends on the year!

'12 go with the 22mm
'13 go with the 24mm to compensate for the increased FSB size.
 
squiggy

squiggy

Cartographer
Super Mod
11,183
6,654
Michiana
Vehicle Model
'12 Civic Si
Body Style
DBP II Coupe
twister8008 said:
I would love to upgrade my suspension a bit. I have an HFP suspension currently with no other mods. I would like to tighten up my suspension with a 24mm rear sway bar. I also would like to shorten up my shifts. I am looking at the buddy club and billet pro sets. Finally, I am looking to install the Boomba Racing engine mount. Can anyone provide guidance, advice, or a testimonial on these products? Thanks for the help!
Click to expand...

Better off spending your money on the rear lower mount from Hasport. Most people will tell you Boomba is junk/bling.
 
Monk

Monk

Well-Known Member
4,218
2,196
SW Virginia
Vehicle Model
2012 Civic EX
Body Style
Coupe FG3:ASM
IIRC, I read on here about that, and there was a hollow tube, but not the same brand as "Progress".
 
You must log in or register to reply here.
Top