650whp or bust

Can't wait to see this when it's done and the slip from the drag strip.:popcorn::popcorn:
 
I'll drag the car for sure, but it won't be that much. The only purpose behind my build is to do roll racing at the poconos
 
Bringing this thread to the top. It's been a dry month after getting my trans stuff.

A little update from today. Block is back from its cylinder support system install. Got my oem girdle back and RSX type S pump. Will be sending those out to PRL Motorsports where they will make the pump fit. Hello 9K redline
B06EEE94-D07E-40E0-BA12-E2DBE7CBD07E_zpsucudevpv.jpg
 
I can post the part numbers for the washers/bolts/lube, but unfortunately I can't do that for the bolts as they came individually wrapped. You have to contact arp and give them measurements for them to make the studs
 
  • Like
Reactions: Nix
ripply said:
I can post the part numbers for the washers/bolts/lube, but unfortunately I can't do that for the bolts as they came individually wrapped. You have to contact arp and give them measurements for them to make the studs
Click to expand...
I was unaware they did custom orders but that's cool. I have a set of studs on my project and they were a great investment considering the head has been off 3 times since I put them in.
 
bootyluvr said:
Motorcycle looks mean!
Click to expand...

Flightmaster127 said:
Awesome lights on the motorcycle!
Click to expand...

Thank you :). I also added in switches to controll all the accessories as I heard LED bulbs like this tend to burn up rather quick if they are on at the same time as the hid.
1F27B3FB-C096-4680-9A97-DF947B4346A2_zpsmr54geek.jpg


I wanted to add the audi style strips, but I felt like that would have overdone it and decided to go against it. I also wired up the projectors so both are fired on when the switch is to the low beam position
 
On my way to go pick up my twin disk and see my block, pistons, and rods. Stay tuned for more pictures
 
  • Like
Reactions: Nix
You must log in or register to reply here.
Back
Top