lighting diagram

F

Frenck

Member
Messages
6
Reaction score
0
Location
Québec, Canada
Vehicle Model
SI
Body Style
Coupe
Hi everybody, i need the electrical diagram for the light : low beam, high beam and fog. Somebody can help me !
 
What are you trying to do that you need the diagram for all the wiring?
 
He was asking what you were trying to do. Depending on what it is, someone may be able to tell you what wires to tap into etc
 
I what check for change all the setup, put some relay and make some modicfication. Im not trying to tap something but thanks for that an sorry for my english! :)
 
So you want HID kit for high beams, low beams, and fog lights?

HIDs are great in the Low beam but not for high beams.
 
Thanks Nix for the info i dont know that but why its not great in the high beams ?
 
The high beam bulb is your daytime running light bulb at reduced power.
 
  • Like
Reactions: Nix
Also an HID bulb needs a few seconds to warm up before it is at full power. Trying to flash your high beams will be near impossible and put a lot of strain on the bulb itself. You could certainly pull the DRL fuse and just use the high beams only on that bulb, but again, usually you don't run your high beams for very long and the HID bulb might not perform how you need it to.

If you are just wanting the color of all the bulbs to match you can go with an LED bulb in the DRL/highbeam. The LEDs do not throw a lot of light so you basically "lose" your high beams but you get the same "color" as the low beam. Say you had 6k low beams and wanted the DRL/highs to look like 6k bulbs. You could pull the DRL fuse and drive around with your high beams on or get an LED bulb that looks like a 6k color temp.

Just another option.

Just installing an HID kit with the correct relay harness you will not have to tap or splice anything. It's all very plug and play and uses the stock wiring and controls. The harness plugs into the ballasts and those into the bulbs. The end of the harness plugs into the drivers side stock headlight wiring and then you connect a power cable directly to the battery and attach all the ground points. It's that easy. It looks complicated in online pictures but once you have the parts in hand and you can lay out all the connections and see how it all fits together one way it is a lot easier to understand.
 
I want the HID for the power of lightning not the color but thanks for the tip of the LED.

For the diagram i want see it if i can close the high beam for the day light and open the fog at this place. Second time when i open my high beam i want the fog stay on. I really need the electrical diagram for all the ligth for see if i can do something.

For the higt beam i understand the bulb need to be hot for have the full power you have another option or some remplacement bulb for true power ?
 
so how does the DRL work with the hid's though, are they still only at reduced power until you flick the high beams on> then to 100% light output?
 
Last edited:
You must log in or register to reply here.
Back
Top