Rear Sway, short throw shifter, and engine mount help

twister8008

twister8008

Well-Known Member
Messages
859
Reaction score
480
Location
Omaha, NE, but I am a Wisconsinite
Vehicle Model
Civic SI
Body Style
Coupe
I would love to upgrade my suspension a bit. I have an HFP suspension currently with no other mods. I would like to tighten up my suspension with a 24mm rear sway bar. I also would like to shorten up my shifts. I am looking at the buddy club and billet pro sets. Finally, I am looking to install the Boomba Racing engine mount. Can anyone provide guidance, advice, or a testimonial on these products? Thanks for the help!
 
The 22mm is a better choice for a rear sway bar, imo. Unless you'll be tracking your car in an occasional manner. It's also about $100+ cheaper than the 24mm. With that you can get better sway bar bushings and beefier end links from MOOG. Here's a thread I made regarding the Progress bushings: http://9thcivic.com/forum/threads/rear-sway-bar-bushing-upgrade.10188/
 
Dar-Dar said:
The 22mm is a better choice for a rear sway bar, imo. Unless you'll be tracking your car in an occasional manner. It's also about $100+ cheaper than the 24mm. With that you can get better sway bar bushings and beefier end links from MOOG. Here's a thread I made regarding the Progress bushings: http://9thcivic.com/forum/threads/rear-sway-bar-bushing-upgrade.10188/
Click to expand...

Depends on the year!

'12 go with the 22mm
'13 go with the 24mm to compensate for the increased FSB size.
 
twister8008 said:
I would love to upgrade my suspension a bit. I have an HFP suspension currently with no other mods. I would like to tighten up my suspension with a 24mm rear sway bar. I also would like to shorten up my shifts. I am looking at the buddy club and billet pro sets. Finally, I am looking to install the Boomba Racing engine mount. Can anyone provide guidance, advice, or a testimonial on these products? Thanks for the help!
Click to expand...

Better off spending your money on the rear lower mount from Hasport. Most people will tell you Boomba is junk/bling.
 
squiggy said:
Depends on the year!

'12 go with the 22mm
'13 go with the 24mm to compensate for the increased FSB size.
Click to expand...
I thought the 2013+ have hollow tubed sway bars.
 
I could be wrong. Lol.
 
IIRC, I read on here about that, and there was a hollow tube, but not the same brand as "Progress".
 
You must log in or register to reply here.
Back
Top