Pauly99to17
Well-Known Member
You're still on OEM Si rims right? How big are your spacers?
323's Build
- Thread starter 323
- Start date
- Thread starter
- #742
Yes I am, and they're all 20mm
Pauly99to17
Well-Known Member
I'm putting 15 mm on mine and really hope they don't rub at all. @hotdogjohnny has 15 mm and said he had no rubbing at all. Weird that 5 mmm makes that much of a difference?
Last edited:
- Thread starter
- #744
Well my car is already lowered on coilovers, I'm sure that's the main cause
Pauly99to17
Well-Known Member
Ahhhhhhhhh.....making sense now.
Nix
Jötunn Moderator
@Dennis Rockholt - Spacer discussion directly above.
@323 - Dennis is considering some spacers. I pointed him here and suggested he ask you about particulars since you are running some. Also which spacers did you end up going with? Did they have the pre pressed studs or did you swap yours out for extended? With the 20mm spacer is the stock stud flush with the top of the spacer or is it sligthly sunken? I am curious if you could run a 15mm spacer or if the stud would stick out and prevent the wheel from being mounted fully.
@323 - Dennis is considering some spacers. I pointed him here and suggested he ask you about particulars since you are running some. Also which spacers did you end up going with? Did they have the pre pressed studs or did you swap yours out for extended? With the 20mm spacer is the stock stud flush with the top of the spacer or is it sligthly sunken? I am curious if you could run a 15mm spacer or if the stud would stick out and prevent the wheel from being mounted fully.
- Thread starter
- #747
Pauly99to17
Well-Known Member
I have 15 mm inchiba V2 hubcentric spacers. The same that @hotdogjohnny1 has.
- Thread starter
- #749
- Thread starter
- #750
- Staff
- #751
- 52,105
- 22,314
On the 8th gen people said :
"In FlashPro open your cal. Go to calibration, select Fuel and enter currrent injector size. You'll need to get latency values for 1000cc injectors from vitviper or someone".
@VitViper would prob be the one to confirm its the same on the 9th gen.
"In FlashPro open your cal. Go to calibration, select Fuel and enter currrent injector size. You'll need to get latency values for 1000cc injectors from vitviper or someone".
@VitViper would prob be the one to confirm its the same on the 9th gen.
- Thread starter
- #752
- Thread starter
- #754
I didn't take it for a test drive because it's raining and the adhesive on the visors need to dry, but I can't wait to feel the difference
- Thread starter
- #755
I find they make a difference in slow-er corners, they keep the car more stable for sure.
- Thread starter
- #756
- Staff
- #757
- 25,544
- 10,598
- Thread starter
- #758
- Staff
- #759
- 25,544
- 10,598
:'(