NopeWhen You disconnect the I-MID for this mod, do you have to enter a code for the radio?
I don't really understand. Could you post a picture?For the 32 pin connector, how does the black part on the connector move up. It seems to firmly set on the connector. Does the black part hold in the pins of the wire?
For the 32 pin connector, how does the black part on the connector move up. It seems to firmly set on the connector. Does the black part hold in the pins of the wire?
Yes sir it doesGreat write-up! I didn't have time to sift through 18 pages of comments. Did anyone confirm if this will work with the Si model?
It was so long ago that I did all this so my memory is a bit foggy. I'll try to answer your questions though. The splicing of the RCA cable idea makes sense to me.I am ordering everything I needs but I have a question regarding the male RCA cable.
i don't understand why the male connector needs to be opened up...
Couldn't I just cut the wire prior the connector and remove the insulation of both wire?
I was considering running the rca cable with an male-male rca extension up to my front dash, and then using a female rca splitterto wires to do a cleaner job:
Amazon productView: http://www.amazon.com/IEC-Speaker-Female-Black-adapter/dp/B003U44LBM
EDIT: I just read Joe Liu comments about tapping the reverse light fuse in the front fusebox... Would it do the same result as running the wire from the trunk up to the front dash? I really hate to run wires through cars, it damages the rugs and there always seems to be connections problems...
So basically I could be powering up the camera from splicing one of my 2 reverse light, wiring the rca cable up front and using a add a circuit to send the reverse light signal to I-Mid...
Does that makes sense?..