Honda-Fan
Well-Known Member
I washed mine!
Official 'What did you do to your car today?' Thread
- Thread starter Dar-Dar
- Start date
Honda-Fan
Well-Known Member
That fitment!
bootyluvr
Well-Known Member
Damn. Everyone been having nice weather.
Rained here most of yesterday.
Rained here most of yesterday.
stilletto
Well-Known Member
Finally sorted my front suspension. Extended the front struts by like 20mm or so so I can run less pressure in the bags. Rides way better now.
Sent from my iPhone using Tapatalk Pro
Sent from my iPhone using Tapatalk Pro
@stilletto how did you that? Just loosen up the strut and move it manually? Just like a coilover? You don’t have to remove the entire assembly off the car right?
stilletto
Well-Known Member
First air out then remove the tie rod from the strut, pull the bolt out of the knuckle, spread the knuckle so the strut falls out and then rotate the bottom portion of the strut. Just support the hub with a jack so you don’t damage the axle. Air Lift lists an ideal PSI range for the fronts and backs.
Sent from my iPhone using Tapatalk Pro
Honda-Fan
Well-Known Member
Those new lamps look sharp! I've always wanted to know-- is there a difference in utility for the different fog light colors?
- Staff
- #6,111
- 52,105
- 22,314
Yellow is supposed to cut through fog better, and reflect less light back at the drivers eyes. Same goes for rain/snow on the road.
- Staff
- #6,114
- 52,105
- 22,314
View: https://m.youtube.com/watch?v=XQheqka2veE&t=218s
Think of ski goggles. Almost all of them are an amber color stock. It helps with cutting down snow glare and gives you some contrast.
Think of ski goggles. Almost all of them are an amber color stock. It helps with cutting down snow glare and gives you some contrast.
Verzerrung
Well-Known Member
Took my door panel off so I can change out the checker tomorrow when the part comes in. I also took of the disgusting armrest that I have been waiting forever to do. I also wanted to take out the part above the armrest so I can vinyl wrap it, but it's not screws that hold it in. Something melted plastic rivets or something of the sort?
Honda-Fan
Well-Known Member
Took my door panel off so I can change out the checker tomorrow when the part comes in. I also took of the disgusting armrest that I have been waiting forever to do. I also wanted to take out the part above the armrest so I can vinyl wrap it, but it's not screws that hold it in. Something melted plastic rivets or something of the sort?
Man, you ain't playin' around! Hahaha
Verzerrung
Well-Known Member
They look like plastic rivets that are stuck on there, but whenever I find fabric I'll see if I can just squeeze it into the small groove. It gives me a bit of time to figure out how to do it since I don't want to just spray glue on the plastic. I could care less about the armrest, but I'll see if I can get my hands on something cheap for now since not a lot is open.
Honda-Fan
Well-Known Member
Does it look sort of pasty like these? I think that's a coating that can be removed. It should have little Phillips-head screws underneath.
Last edited:
- Staff
- #6,119
- 52,105
- 22,314
Verzerrung
Well-Known Member
Similar yes, here is mine.Does it look sort of pasty like these? I think that's a coating that can be removed. It should have little Phillips-head screws underneath.
