Official 'What did you do to your car today?' Thread

Flippercon said:
I used a piece if plastic to pry the panels apart to slide it in spot. Once it is started it is pretty easy after that. I will try to find the seller when I get to my cpu.
Click to expand...
Did you go all the way to the frt of the door(the section that you can't see when the door is closed) ? I ordered 10 feet in case I go that far.
Total 120 feet.
 
Monk said:
Did you go all the way to the frt of the door(the section that you can't see when the door is closed) ? I ordered 10 feet in case I go that far.
Total 120 feet.
Click to expand...
I did at first on the drivers side but ended up trimming it. It didn't look right and you only can see it when the doors are open. I would have just enough to do it that way with 3 yards.
 
Flippercon said:
I did at first on the drivers side but ended up trimming it. It didn't look right and you only can see it when the doors are open. I would have just enough to do it that way with 3 yards.
Click to expand...
Yeah, that's what I was wondering, about how it would look.......... I'll try it to see, and remove if I don't like.... Suppose to be here on Friday.
Thx....
 
Monk said:
Yeah, that's what I was wondering, about how it would look.......... I'll try it to see, and remove if I don't like.... Suppose to be here on Friday.
Thx....
Click to expand...
Another thing that was a pain was the sections that would not go in all the way. I laid all the pipe down and found a few spots that would not go in completely, so I pulled it back to those points and trimmed some of the backing off so it had enough room to seat properly.
 
Flippercon said:
Another thing that was a pain was the sections that would not go in all the way. I laid all the pipe down and found a few spots that would not go in completely, so I pulled it back to those points and trimmed some of the backing off so it had enough room to seat properly.
Click to expand...
Good to know, so I can have tools ready to correct the areas ..........
 
uruty6ut.jpg


My friend gave me a set of yellow nokya bulbs he had lying around. Woooo for freebies
 
Got my Orange piping in a day early, so ya'll a have to function a few hours without me....... :D
 
Monk said:
Got my Orange piping in a day early, so ya'll a have to function a few hours without me....... :D
Click to expand...

Good luck! I am curious to see how it turns out. I will probably do that next after I am done with the stereo and backup camera.
 
Got'er done and took a pic of it, now I'm trying to post the pic, but haven't gotten into Tinypic's yet, due to forgetting password, then a try again later notice....... I hate it when !!!!!!!!!
 
Last edited:
Flippercon said:
Looks great. How was the install? What did you use to pry the panels apart?
Click to expand...

Same as a credit card, but nothing that was of any use if broken...... I did the top back of door 1st, and found it too hard to open the bottom, so pulled the top and did the bottom, then did the top last.
That section at the bottom near the little coin holder and buttons where it does the s turns, it's a tad loose, so I cut the bead and ran the flange under/into the part that covers it so the flange acts as a holder......if that makes since.
 
You must log in or register to reply here.
Back
Top