Fiji Blue Pearl Coupe Coolest Member Since: May 15, 2011
My wheel baking setup. The heat gun only has a min heat setting at 400F. I dont need 400F, it's too high. At least the blow dryer can get hot enough. I wish I had a thermal scanner though.
Ok, so I test fit my DigitalFits in my car and this is what I saw. Large gap here between left side of floor edging and the left side of the mat (area that I have circled, in the image)..... haven't actually had a chance to use them because I didn't know if this was a defect?? Can anyone chime in, and let me know if this will work itself out or if should I contact WeatherTech?
Mine don't fit like that. I'm guessing it's the way they were folded when shipped? Mine came in a box and weren't bent at all that I can remember. I'd suggest to give them a few days to settle to see if that works itself out. If it doesn't, contact Weathertech.
andre12dbsi, jassmi, LizBot, ADExternal... thanks all for your advice. They were bent from shipping, have them in the house at the moment so they can warm up and hopefully settle back to original form. I'll try them back in my car in a day or 2.
Took the splash guards off (looks better imo) and gave it a much needed wash after the 900+ miles I put on over the last 5 days... lots of traveling. ..
Took the splash guards off (looks better imo) and gave it a much needed wash after the 900+ miles I put on over the last 5 days... lots of traveling. ..