Post Your Latest Purchases

[Nevtec]

Oh haha. I was gonna say that's a dam clean 07 :P

 

[323]

Just ordered my Megan Racing Street Series coilovers from @wesellcarparts !!

 

[CivicCanuck]

FKX Racing:

1x tower bar
1x front lower tie bar
1x rear lower tie bar
1x x brace
1x trunk brace

 

[Dar-Dar]

Not bad for $22 shipped.

 

[Dar-Dar]

Sold my Skunk2 SS adapter and bought a Ralco short shift adapter.

 

[bobshur]

start of lighting project

 

[mpheng]

@Dar-Dar Would you think the JDM emblems would fit the 13' Sedans? I would love to get those!

 

[KennyGS]

FKX Racing:

1x tower bar
1x front lower tie bar
1x rear lower tie bar
1x x brace
1x trunk brace

Installed yet? Noticeable improvement?

 

[Dar-Dar]

@Dar-Dar Would you think the JDM emblems would fit the 13' Sedans? I would love to get those!

Im not sure if the 8thgen and 9thgen can both use the same sets of jdm emblems. I'll check around.

 

[CivicCanuck]

Installed yet? Noticeable improvement?

Not installed yet... just picked up the last 2 pieces. Going to install them when I have a chance, but it may not be for a few months, I have been working and concentrating on my truck, it's on the road but there are a lot of loose ends to tie up. It's already started snowing, and I haven't even rustproofed for the season yet.

Would be nice to get some back to back runs in the same day with and without to see the difference.

 

[LizBot]

Autocraft Silver Battery




Didn't feel like shopping around. So I hope this lasts at least a handful of years.

 

[bobshur]

All I have left is the trunk mount, Erik si has a 12 send si stock and he drove my car aggressively,he could tell you the difference.

 

[323]

I signed up for Amazon prime, then went on a spree to get my garage organized

Once I get them organized, I can figure out what exactly I'm missing and complete the set.

Also got a cheap torque wrench

 

[team3d]

bought this car 5 days ago...

 

[FB2Chris]

View attachment 29109 View attachment 29110 View attachment 29111 View attachment 29112

bought this car 5 days ago...

No more Civic?

 

[91alexm]

UAE Projector Headlights

 

[J-Rizzy615]

work emotion cr kai

 

[CivicCanuck]

Just fabricated this sweet panel last night for my pickup. Installed a GM 4 pin weatherpack connector on the main harness, and a 2 pin on the output from the switches.

Gauges are Intelletronix, trans temp and voltage. This console had a large opening at the front, originally in a Tahoe. ( they had rear heat controls there ) Pickups got a smaller opening on the console and a blank filler panel, the tahoe and suburban consoles are the perfect size for 2 1/16" gauges. Autometer angle rings rotate the gauges up towards eye level and towards the driver.

Made a template from thin cardboard and transferred that to 1/4" black smoked Acrylite sheet. I had to use two pieces of 1/4" to make up for the thickness of the original temp controls and be flush in the opening.

 

[team3d]

No more Civic?

i have both now....

 

[squiggy]

Some OEM headlights and two sets of these: